Nordichooldus · NVAC OÜ · Tallinn and Harju County+372 5619 7399
Nordichooldus.ee Request a quote

VENTILATION AND AIR CONDITIONING GUIDES

Ventilation faults and error messages: where to start?

A symptom describes what you notice. An error code is a message from a specific controller. Neither alone proves which part needs replacing.

Record the right information before resetting

  • Photograph the whole message, not just a red light. Record when it happened.
  • Find the manufacturer, exact model and, if available, production year on the plate. Record the controller designation.
  • Explain whether airflow changed in every room or just one, and whether the problem is constant or occurs in cold weather.
  • Include the last filter change, recent adjustments or building work and the current mode.

Do not erase error history before saving it. Recurring alarms need investigation. Restarting is not a repair.

Ventilation runs but airflow is weak

Start at the controller: has a schedule, away mode or automatic control reduced speed? Then check filter condition and fitting according to the manual. Inspect safely accessible intakes and whether furniture or blocked transfer openings obstruct air movement.

A single-room issue may involve a local air path; a whole-house issue may involve the unit, filters or main ducts. These are investigation directions, not diagnoses. If initial checks do not explain the change, arrange airflow measurements and a system inspection.

Ventilation hums, whistles or vibrates

New noise may follow higher fan speed, dirty filters, restricted air paths or vibrating mounts. Metallic scraping and strong vibration need technical inspection. Do not adjust supply or extract valves just to reduce noise. Balancing requires airflow measurement.

Describe whether the sound comes from the unit, duct or one terminal and in which mode it starts. A recording helps describe it but does not replace inspection.

Supply air is cold

Compare room temperature with displayed supply temperature. Heat recovery does not always supply room-temperature air. Persistent changes may require checks of filters, flows, heat exchanger, bypass or heating. Frost protection and defrosting can temporarily change operation.

Do not disable frost or overheating protection. Use the correct model manual to interpret a low-temperature alarm.

Water or odours near the unit

Water may relate to condensate drainage, a trap, icing or insulation. Do not pour water near electrical parts or open electrical compartments. For persistent leaks, stop as instructed and arrange inspection. For odours, consider intake location and building pressure as well as filters.

For smoke, burning smells, a fire alarm or visible electrical damage, stop routine troubleshooting and do not reset protection. In immediate danger, leave the area and call 112.

Choose error guidance by manufacturer and controller

The Airobot guide distinguishes filter reminders from fan alarms, for example. The Komfovent C6 examples apply to the specified controls. For Systemair units, identify SAVE or the other series and the controller first. Do not interpret one manufacturer’s code using another’s table.

Related reading

Call usRequest a quote